Water Butt Tank Linking Kits

1/2" BSP is approximately 21 mm
3/4" BSP is approximately 26.4 mm
1" BSP is approximately 33.3 mm
1.25" BSP is approximately 41.9 mm
1.5" BSP is approximately 47.8 mm
2" BSP is approximately 59.6 mm

This linking kit is perfect for redirecting your overflowing excess water from one water butt to another or to a drainage system, with a maximum size of 2" you can adapt a small container, water butt or even an IBC tank! Each kit comes with a length of matching sized pipe and 2x barbed overflow adapters.

These water butt adapters are perfect for direct connection to hose pipes from 1/2" (13mm) to 2" (50mm). These barbed fittings can be push fit onto hosepipe, water pipes, corrugated pond pipes & more! Each fitting comes with a single nut and washer to screw into your water tank.

Installation Instructions:

1. Find the pre-drilled/fitted hole on your tank and see if our adapter is compatible, if it is not compatible then drill a new hole in your place of choice
2. Take the nut off the adapter and leave the washer on the thread, then insert the adapter into the hole from step 1.
3. Then screw on the nut as tight as possible, you do not need to use a tool for this, hand tight with both washers should prevent leaking.
4. Push your pipe onto the connector and tighten with a clip or cable tie to prevent leaking.
5. Repeat on your second tank or container